PEX-A Certification

Welcome to Apollo Expansion PEX (PEX-A) Certification Test. This test is provided to train homeowners in the proper use and installation of Apollo Expansion PEX pipe and fittings. Please watch the "How to Install PEX-A" video or read the Apollo Installation Manual, both above. Afterwards, please answer the multiple choice, ten question quiz below. If at least 8 out of 10 questions are answered correctly, certification will be awarded. A Certificate of Training will be available to download at the end of the quiz to use in accordance with any local plumbing codes that require factory training for PEX installation.

If you pass the quiz and don't see a "Download Certificate" phrase at the end of the quiz, please email Meda at meda@mosackgroup.com.

For any further information or instructions about specific Apollo PEX products, please visit www.apolloflow.com/literature.

Name (First and Last)

Email

Company Name

In what setting can PEX-A be used?

New and existing water distribution systems.

New water distribution systems only.

Existing water distribution systems only.

Only when constructing a new home.

How should PEX-A pipe be prepared before attaching a fitting?

No prep is needed.

Cut the pipe at any angle.

Cut the pipe squarely and clean the end.

Apply flux to the end of the pipe.

How should brass or poly alloy PEX-A fittings be attached to PEX-A pipe?

Use crimp rings and pinch clamps.

Use expansion sleeves.

Use flux.

Use glue.

Where should an expansion sleeve be placed for fastening?

At the very end of the pipe.

At the very end of the fitting.

Wherever you want to place it.

1 inch from the end of the pipe.

What tools can be used to fasten PEX-A fittings?

Electric.

Manual.

Electric or manual.

No tool is necessary.

What fittings can be used with Apollo PEX-A pipe?

PEX-A poly alloy fittings.

PEX-B poly alloy and brass fittings.

PEX-A brass fittings.

All of the above.

How do you remove a PEX-A fitting once it's been fastened to the pipe?

Cut off the pipe with the fitting and blow cold air on the fitting.

Cut off the pipe with the fitting and run the fitting under cold water.

Cut off the pipe with the fitting and run the fitting under hot water.

Cut off the pipe with the fitting and use a heat gun on the pipe and fitting.

What is the job of a manifold?

Controlling water temperature.

Controlling water flow at one spot.

Locating leaks.

Controlling water pressure.

Why do manifolds have so many valves?

To control water flow to each fixture.

To control water pressure to each fixture.

To control water temperature to each fixture.

To control leaks to individual fixtures.

If you need information about Apollo PEX-A products, visit:

http://www.appolo.com

http://www.pex.com

http://www.apolloflow.com

http://www.plumbing.com

PEX-A Certification

Share this:

Like this: